Snapping into your Backbone: 

1 - To snap into your Backbone, insert your phone camera side first to ensure your phone is secured on the left-hand side of the controller. 

2 - Once the left side is secured, use your left hand to hold the phone steady while your right hand extends the Backbone controller to make room for your phone. 

3 - After extending, you should be able to lower the phone into position while lining up the charging port

Removing your Phone:

1 - Start by gripping your phone with your left hand near your Android's camera while holding the right-hand side of the Backbone with your right hand. 

2 - Gently extend your Backbone using these grips to disconnect the charging port connection while keeping your phone flat. 

3 - Once disconnected, use your left hand to tilt the phone up and away from the charging port connector.

4 - Gently pull your phone out, and allow the Backbone to return to it's unextended position slowly. Try not to let the Backbone snap back.

Articles in this section

Was this article helpful?
0 out of 2 found this helpful
Share